| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| 1N5828JANTX | microsemi | 04+ | 23 |
|
|
1N5828JANTX Datasheet LASER DIODE.lnc.. reserves trie right to make changes at any time as deemed practicaland/or necessary to Improve the design and to supply the best possible product. Information provIded Is believed at this time to be accurate and reliable, No responsibility is assumed for its use, nor for any infringements on the rights of others. 'For further informatIon on this product or others of LASER DIODE.lnc., please call: LASER DIODE,INC. MORGAN ELECTRONICS DMSION - - 1130 SOMERSEr ST,NDN BRUNSWICK, NJ 08901 ] . c] D (201) 249-7000 (FAX) 201-249-9165 (TWX) 710-998-0597 -- 1N5828JANTX Price 2)Sleep Mocle Selling The slccp mode can be set by wriLing Lhe code "I" (H level) to the Sleep bit or the serial data. The sleep mode perrorms output inuting, stop Lhe internal clock, stop the memory operzition and put a low current conSL"nption mocle. Normally, this Sleep bit must be "0" (1 level). In order to avoid the shock noise output when the sleep mocle released, mLite runction Lising is recommended. NOTES: 1. "H" = VIH, "L" = VIL, "X" = Don't Care. 2. Read and write operations are controlled by the appropriate setting of R/W, CEo, CEi, BEn and OE. 3. Outputs are in Pipelined mode: the data out will be delayed by one cycle. 4. ADS and CNTRST are independent of all other memory control signals including CEo, CEi and BEn 5. The address counter advances if ~NTEN = VIL on the rising edge of CLK, regardless of all other memory control signals including CEo, CEi, BEn voltage HVc is clamped at an internally set value Vcl, typically 360V. The transition from saturation to desatu ration, coil current limiting phase, must have the ability to accomodate an overvoltage. A maximum overshoot of 20V is allowed. FEEDBACK When the collector current exceeds 6.5A, the feedback signal is turned high and it remains so, until the input voltage is turned-off. OVERVOLTAGE The VB026SP can withstand the following transients of the battery line: -100V/2msec (Ri = 10 I ) +100V/0.2msec (Ri = 10 I ) +50V/400msec(Ri = 4.2 I , with VIN = 3 V) |
