| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| 216PACKA14F-(9600) | BGAMirror | 08+ | 1000 |
|
 |
||
| 216PACKA14F-(9600) | 07+ | 388 |
|
||||
| 216PACKA14F-(9600) | BGA镜 |
|
 |
||||
| 216PACKA14F-(9600) | BGA镜 | 07+ | 388 |
|
|||
| 216PACKA14F-(9600) | 1 |
|
|||||
| 216PACKA14F-(9600) | ATI | 06+ | 500 |
|
|
||
| 216PACKA14F-(9600) |
|
|
|
216PACKA14F-(9600) Datasheet Mitsubishi Electric Europe B.V. Semiconductor Travellers Lane, Hatfield Hertfordshire, AL10 8XB, England Email: semis.info@meuk.mee.com Phone: +44-1707-278-900 Fax: +44-1707-278-837 216PACKA14F-(9600) Price Pin 2 0f the SIT2410802 allows connection of an external resistor RSL, which is used to program the slope of the supply current vs supply voltage characteristics (see Fig. 2) and hence the supply current up to the initial voltage (Vsi). This initial voltage remains constant independent of RSL. The supply current drawn prior to triggering is inversely proportional with RSL, decreasing for an increasing value of resistance. Thus, increasing the value of RSL, will decrease the amount of AC ringing current required to trigger the device. Longer subscriber loops are possible since less voltage is dropped per unit length of loop wire due to the lower current level. RSL can also be used to compensate for smaller AC coupling capacitors (Cs on Fig. 3) (higher impedance) to the line which is used to alter the ringer equivalence number of a tone ringer circuit. 216PACKA14F-(9600) on stock 100 lk 10k 100k 1M 10M 100M FREOUENCY (Hz) 1468 G20 Resale of TI products or services with statements different from or beyond the parameters stated by TI for that product or service voids all express and any implied warranties for the associated TI product or service and is an unfair and deceptive business practice. TI is not responsible or liable for any such statements. Using the calculated values for TR(max) and PD, the maxi- mum allowable value for the junction-to-ambient thermal re- sistance, e(J_A), can now be found: O(J-A) = TR (max)/PD IMPORTANT: If the maximum allowable value for e(J_A) is found to be > 530C/W for the T0-220 package, > 800C/W for the T0-263 package, or >1740C/W for the SOT-223 pack- age, no heatsink is needed since the package alone will dis- sipate enough heat to satisfy these requirements. If the calculated value for O(J_A)falls below these limits, a heatsink is required. |
