suppliers of 5010-013 and PDF data of 5010-013

When optical PMD devices are removed from the board, the signals at their interface to the system should be keptintact, both in logicalcontentand as voltage/current levels - see Figure l. The optical transmitter accepts both "Serial Data Out" from the PHY transmitter and "Output Disable" control (not used in lOS), at P-ECLlev- els. Similarly, the optical receiver supplies "Serial Data In" to the PHY receiver and "Carrier Detect" status (here called "Link Detect") at the same P-ECLlevels. One new signal handled by the copper interface circuit is a status signal, incorporated into Link Detect, that shows that the cable is connected at both ends. It is detected by both transmitterand receiverbecause each one uses a sepa- rate twisted pair.
5010-013 on stock