| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| A32140DX2PQ160C | actel | IN STOCK!P | dc98 | 15 |
|
 |
|
| A32140DX2PQ160C | actel | dc98 | IN STOCK!Pack: 24/tr | 15 |
|
||
| A32140DX2PQ160C | actel | dc98 | IN STOCK!Pack: 3000/ | 15 |
|
||
| A32140DX2PQ160C | actel | IN STOCK!P | dc98 | 15 |
|
||
| A32140DX2PQ160C | actel | IN STOCK! | dc98 | 15 |
|
|
|
| A32140DX2PQ160C | actel | 15 |
|
||||
| A32140DX2PQ160C | actel | dc98 | IN STOCK! pack: 24/t | 15 |
|
||
| A32140DX2PQ160C | actel | dc98 |
|
||||
| A32140DX2PQ160C | actel | dc98 | INSTOCK!vpe:24/tray/ | 15 |
|
|
A32140DX2PQ160C Datasheet I Any and all information described or contained herein are subject to change without notice due to product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the SANYO product that you intend to use. A32140DX2PQ160C Price Data flow from D to Q is controlled by the differential clock (CLK/CLK#) and a control signal (RESET#).The positive edge of CLK is used to trigger the data flow and CLK# is used to maintain sufficient noise margins where as RESET#, an LVCMOS asynchronous signal, is intended for use at the time of power-up only. ICSSSTVA16857 supports low-power standby operation. A logic level "Low" at RESET# assures that all internal registers and outputs (Q) are reset to the logic "Low" state, and allinput receivers, data (D) and clock (CLK/CLK#) are switched off. Please note that RESET# must always be supported with LVCMOS levels at a valid logic state because VREF may not be stable during power-up. A32140DX2PQ160C on stock The RH003A, B, C, BK, and CL Power Modules are dc-dc converters that operate over an input-voltage range of 4.0 Vdc t0 7.2 Vdc and provide precisely regulated 5 V, 12 V, 15 V, f12 V, and +15 V outputs respectively. The outputs are isolated from the inputs, allowing versatile polarity configurations and grounding connections. The modules have maximum power ratings of 3 W at a typical full-load efficiency of 77% t0 83%. The RH003-Series is available with standard straight terminals or with a 900 bend in the terminals for lower profile mounting. This right angle lead form option is shown in the Outline Diagram and the part numbers are listed in the Ordering Information section at the end of this data sheet. The modules are PC board mountable and encapsulated in nonconductive cases. The modules are rated to full load at 50 0C case temperature with no external filtering. |
