N74AHCT1G08DBVR，there are the best N74AHCT1G08DBVR suppiers all over the world here.These are the list and detailed contact method of N74AHCT1G08DBVR suppliers all over the world as follows.You can buy or get informations of N74AHCT1G08DBVR through email , message or tel.

suppliers of N74AHCT1G08DBVR and PDF data of N74AHCT1G08DBVR

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

N74AHCT1G08DBVR Datasheet

Parameter		Symbol	Limits	Unit
	Forward current	IF	50	mA
LU _J =	Reverse voltage	VR	5	v
o	Power dissipation	PD	80	mW
_-	Collector-emitter voltage	VCEO	30	v
	Emitter-collector voltage	VECO	4.5	v
	Collector current	lc	30	mA
	Collector power dissipation	Pc	80	mW
Opera	ing temperature	ropr	-25+85
Storage temperature		Tstg	-30+85

N74AHCT1G08DBVR Price

SYMBOL	PARAMETER	CONDITION		MIN	TYP?	MAX	UNITS
VOL	Output Low Voltage	101=8 mA				0.4	V
VOH	Output High Voltage	IOH=4 mA		2.4			V
IIL	Input or l/0 Low Leakage Current	OV " VIN " VL (Max.)				-10	cCA
IIH	Input or l/0 High Leakage Current	3.5V 'r VIN'r VCC				10
IIL-isp	ispEN Input Low Leakage Current	OVVINVIL				-150
IIL-PU	I/O Active Pull-Up Current	OVVINVIL				-150	cCA
losl	Output Short Circuit Current	Vcc= 5V, VOUT= 0.5V				-200	mA
		VIL= 0.5V, YH = 3.OV	Commercial		190		mA
ICC2,4	Operating Power Supply Current	fCLOCK = 1 MHz	Industrial		190		mA

N74AHCT1G08DBVR on stock

The algebraic convention is used in this data sheet; the most negative value is shown in the minimum column. CRON = RON(max) - RON(min) On-resistance match between channels and on-resistance flatness are guaranteed only with specified voltages. Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the specified analog signal range. Leakage parameters are 100% tested at maximum rated hot temperature and guaranteed by correlation at room temp. Guaranteed by design. Leakage testing at single supply is g uaranteed by testing with d ual supplies. See Fig ure 6. Off isolation = 2010910 VCOMNNO, VCOM = output. NO = input to off switch. Between any two switches. See Figure 3.

		lour= 100mA

Tj= -4(	)IC
		Tj= +25IC
		' - -- I -j I \
		/ Tj = +125IC
	Tj= +85IC

Suppliers Datasheet
		Exact Matc