| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| N74F86N602 | NXP | original | 50000 | 2008 |
|
N74F86N602 Datasheet
N74F86N602 Price The differential PECL data from TXIP, TXIN goes through a MLT3 Encoder. The MLT3 encoder is enabled when the TPMODE pin is LOW. The data is encoded per the follow- ing rules: The encoded output takes on one of three possible levels: High, Middle, or Low. Whenever the input signal changes state, the output will also change state. If the output is in the middle state, the state to which it will change to is dependent on the previous state. If the previous state was high(low), then the output will change to alow(high) state from the middle state. If the output is at either a high or a low state, then the next transition will cause the output to change to the middle state. The encoder conforms to the dia gram shown in Figure l. N74F86N602 on stock Notes: 1. Load and Line Regulation are specified at a constantjunction temperature. Pulse testing with low duty cycle is used Changes in output voltage due to heating effects must be taken into account separately. 2. If not tested, shall be guaranteed to the specified limits. 3. The ' denotes the specifications which apply over the full operating temperature range. Won-Top Electronics Co., Ltd (WTE) has checked all information carefully and believes it to be correct and accurate. However, WTE cannot assume any responsibility for inaccuracies. Furthermore, this information does not give the purchaser of semiconductor devices any license under patent rights to manufacturer. WTE reserves the right to change any or all information herein without further notice. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
