N74LS373D，there are the best N74LS373D suppiers all over the world here.These are the list and detailed contact method of N74LS373D suppliers all over the world as follows.You can buy or get informations of N74LS373D through email , message or tel.

suppliers of N74LS373D and PDF data of N74LS373D

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
N74LS373D	SIG	TUBE	SMD		814	JR INTERNATIONAL( HK )CO.,LIMI.. Contact:li Tel:86-755-83828289 Fax: Email: abcd@jrdz-hk.com
N74LS373D	SIG	SMD	87	原装现货	814	BH International Electronics C.. Contact:gu Tel:86-10-62410301 Fax: Email: gugongliu@126.com
N74LS373D			SMD		10000	JR International (HK) Co., Lim.. Contact:zhang Tel:86-755-83828289 Fax:86-755-82515549 Email: any818@163.com
N74LS373D	814					E-CX COMPANY Contact:lucyhan Tel:86-10-62106372/62105953 Fax:86-10-62102241 Email: partmate@hotmail.com
N74LS373D	SIG		87		814	HK XINYUHANG ELECTRONIC CO.,LT.. Contact:CrystaPan Tel:0086-755-83995390 Fax:0086-755-88363122 Email: xyhic@szxyh.com
N74LS373D	814		NE			HK XINYUHANG ELECTRONIC CO.,LT.. Contact:Mr.liuyehui Tel:86-755-83995387 Fax:86-755-83995096 Email: liuyehui2006@sina.com

N74LS373D Datasheet


>								jf jt
	ta(A)							tv(A) L

l		to (S1)					f
		jl
(Note 3)							tdis (S1)			(Note 31

jj		jf to (S2)			l		l
(Note 31		to (OE)					tdis (S2)			(Note 31
			ten (OE)
		l	{		f	f
(Note 31						tdis (OE)				(Note 31
		ten (S1)
		ten (S2)		f	< DATAVALID )				{
W= "H" IP.VPI				l					?

N74LS373D Price

This series consists of precision, active filters with frequency selectable by front panel controls in l/10 decade steps. This provides 10 equally spaced set- tings per decade on a logarithmic scale, and permits bandpass operation in octave, decade, and other convenient bandwidths. Phase and amplitude track- ing between filters with the same setting will be within +40 and +.2 dB respectively.
N74LS373D on stock

17 1

jOC

250

| -

in the '1' state. Data is introduced by selectively programming 'O's into the desired bit locations. Al- though only 'O's will be programmed, both '1's and 'O's can be present in the data word. The only way to change a '0' to a '1's by die exposure to ultravi- olet light (UV EPROM). The M27W512 is in the programming mode when VPP input is at 12.75V and E is pulsed to VIL. The data to be programmed is applied t0 8 bits in parallel to the data output pins. The levels required for the address and data inputs are TTL. Vcc is specified to be 6.25V +

Suppliers Datasheet
		Exact Matc