| OUTPUT |
| Maximum Value: | +3000 Volts (VHiqri - VLow) |
| Minimum Value: | 0 Volts |
| Means Of Adjustment: | Controlled By Power Supply Input Voltages |
| Pulse Rise And Fall Time: | <25ns (10% t0 90%) |
| Pulse Width: | <60ns (typically 55ns) to DC, Controlled by Input Gate |
| Pulse Recurrence Frequency (PRF): | Single shot to >25KHz at 3000V continuous output, maximum limited by power dissipation ('), 5MHz Burst, Controlled by Input Gate |
| Max. Average Power: | 50W (VHiqh + VLow)1' |
| Max. Duty Cycle: | Continuous |
| Droop: | <1% |
| Over/undershoot: | <5% |
| Throughput Delay | 120ns Typical |
| Jitter | <200ps shot-to-shot |
| Output Connector & Cable: | SHV, With 2 feet (~61cm) RG-62 (931 ) Coaxial Cable |
| INPUT DC VOLTAGE +VIN (VHigh) |
| Absolute Max. Value: | +3000 Volts |
| Absolute Min. Value: | -3000 Volts |
| Relative Max. Value: | +3000 Volts over VLow Voltage |
| Relative Min. Value: | +OV Over VLow Voltage |
| INPUT DC VOLTAGE -VIN (VLow) |
| Absolute Max. Value: | +3000 Volts |
| Absolute Min. Value: | -3000 Volts |
| Input DC Connectors: | SHV, End Panel (One each for +VIN and -VIN) |
| GATE |
| Gate Source & Connector | TTL into sol , into BNC connector on the end panel |
| VOLTAGE & CURRENT MONITORS |
| Voltage Monitor: | 1000:1 int0 1 Meg I , BNC connector |
| Current Monitor: | 10AN into sol , BNC connector |
| GENERAL |
| Support Power: | +24VDC To +28VDC @ 250mA Max Operating Cur- rent, 1A Starting (inrush) current |
| Dimensions (Excluding Con- nectors): | 9.8" W x 10.2" L x 2" H (249mm W x 259mm L x 51mm H) |
| Weight (Approximate): | 56 0unces (1.6 Kilograms) |
| SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE |
| |
