NACY220M16V5X6.3TR13F Datasheet| Cha racteristics Symbol Test Conditions | Min | Typ | Max | Units | | Input Capacitance Cies | | 72 | | nF | | Output Capacitance Coes VGE = OV VCE = 10V | | 5.3 | | nF | | Reverse Transfer Capacitance Cres | | 1.6 | | nF | | Resistive Turn-on Delay Time td(on) VCC = 2250V, lc = 400A, | | | 2 4 | | | Load Rise Time tr VGEl = VGE2 = 15V, | | | 2 4 | | | Switching Turn-off Delay Time td(off) RG = 22.5 I | | | 6 0 | | | Times Fall Time tf Resistive Load Switching Operation | | | 1 2 | | | Diode Reverse Recovery Time" trr IE = 400A, diE/dt = -800Ncs | | | 1 8 | | | Diode Reverse Recovery Charge" Qrr IE = 400A, diE/dt = -800Ncs | | 160* | | c | | ' Pulse width and repetition rate should be such that device junction temperature rise is negligible "Represents characteristics of the anti-parallel, emitter-to-collector free-wheel diode (FWDi). | | | | | | Thermal and Mechanical Characteristics, Tj = 25 IC unless otherwise specified | | Cha racteristics Symbol Test Conditions | Min. | Typ. | Max. | Units | | Thermal Resistance, Junction to Case RthO_c) Q Per IGBT | | | 0 023 | K/W | | | | | |
NACY220M16V5X6.3TR13F Price| SYMBOL | PARAMETER | CONDITIONS | MIN TYP MAX | UNITS | | fEOSC | External Oscillator Frequency Range | (Note 15) | @ | 1 0 4000 | kHz | | tHEO | External Oscillator High Period | | @ | 0.125 1 00 | | | tLEO | External Oscillator Low Period | | @ | 0.125 1 00 | | | LCONV 1 | Conversion Time for ix Speed Mode | 50Hz Mode 60Hz Mode Simultaneous 50Hz/60Hz Mode External Oscillator | @ @ @ @ | 157.2 160.3 163.5 131.0 133.6 136.3 144.1 146.9 149.9 41 036/fEOSC (in kHz) | ms ms ms ms | | LCONV 2 | Conversion Time for 2x Speed Mode | 50Hz Mode 60Hz Mode Simultaneous 50Hz/60Hz Mode External Oscillator | @ @ @ @ | 78.7 80.3 81.9 65.6 66.9 68.2 72.2 73.6 75.1 20556/fEOSC (in kl-lz) | ms ms ms ms | | lISCK | Internal SCK Frequency | Internal Oscillator (Note 10) External Oscillator (Notes 1 0, 11) | | 38.4 fEOSC/8 | kHz kHz | | DISCK | Internal SCK Duty Cycle | (Note 10) | @ | 45 55 | % | | lESCK | External SCK Frequency Range | (Note 10) | @ | 4000 | kHz | | tLESCK | External SCK Low Period | (Note 10) | @ | 1 25 | ns | | LHESCK | External SCK High Period | (Note 10) | @ | 1 25 | ns | | LDOUT lSCK | Internal SCK 24-Bit Data Output Time | Internal Oscillator (Notes 10, 12) External Oscillator (Notes 10, 11) | @ @ | 0.61 0.625 0.64 1 92/fEOSC (in kHz) | ms ms | | LDOUT ESCK | External SCK 24-Bit Data Output Time | (Note 10) | @ | 24/fESCK (in kHz) | ms | | 11 | CS l, to SDO Low | | @ | 0 200 | ns | | 12 | CST to SDO High Z | | @ | 0 200 | ns | | 13 | CS l, to SCK l, | Internal SCK Mode | @ | 0 200 | ns | | t4 | CS l, to SCKT | External SCK Mode | @ | 50 | ns | | LKQMAX | SCK l, to SDO Valid | | @ | 200 | ns | | LKQMlN | SDO Hold After SCKI | (Note 51 | @ | 1 5 | ns | | 15 | SCK Set-Up Before CS l, | | @ | 50 | ns | | 16 | SCK Hold After CSJ, | | @ | 50 | ns | | 17 | SDI Setup Before SCKT | (Note 51 | @ | 1 00 | ns | | 18 | SDI Hold After SCKT | (Note 51 | @ | 1 00 | ns | | | | | | |
NACY220M16V5X6.3TR13F on stock| | | | | LIMITS | | | SYMBOL | PARAMETER | TO | FROM | Min | Typi | Max | UNIT | | Access tlmez | | tAA tCE | | Output Output | Address Chip Enable | | | 50 30 | ns ns | | Dlsable timez | | tCD | | Output | Chip Disable | | | 30 | ns | | | | | | | | |
| I Absolute maximum ratings : (Ta=250C) | | | Parameter | Symbol | Ratings | Unit | Notice | | | Supply Voltage | Vcc | O6 | V | | | Operating Temperature | Topr | -20+75 | | | | Storage Temperature | Tstg | -20+85 | | | | Soldering Temperature | Tsol | 260 | | 4mm from mold body less than 5 seconds | | I Electro Optical Characteristics : (Ta=250C) | | | Parameter | Symbol | MIN | TYP | MAX | Unit | Condition | | | Supply Voltage | Vcc | 4.5 | 5 | 5.5 | V | DC voltage | | Supply Current | Icc | | | 3 | mA | No signal input | | B.P.F Center Frequenc3r | fo | | 3 8 | | KHz | | | Peak Wavelength | p | | 940 | | nm | | | Transmission | Lo | 8 | | | | At the ray axis | | Distance | L45 | 4 | | | m | *1 | | Half Angle (Horizontal) | Oh | | 45 | | deg | | | Half Angle ( VerticaD | v | | 35 | | deg | | | High Level Pulse Width | TH | 400 | | 800 | ocs | At the ray axis | | Low Level Pulse Width | TL | 400 | | 800 | ocs | | High Level Output Voltage | VH | 4.5 | | | V | | | Low Level Output Voltage | VL | | 0.2 | 0.5 | V | | | *l:The ray receiving surface at a vertex and relation to the ray axis in the range of= OYand Q=45Y. *2:A range from 30cm to the arrival distance. Average value of50 pulses. | | | | | | | | | | | | |
|
