PC612H503AX30 Datasheet| Circuit current | 101 | | 0 3 | 1 0 | mA | No load | | Standby current | 102 | | | 5 | UA | No load, STBY=OV | | | | | | | |
PC612H503AX30 Price NOTE : 1. The K9F5608UOA may include invalid blocks when first shipped. Additional invalid blocks may develop while being used. The number of valid blocks is presented with both cases of invalid blocks considered. Invalid blocks are defined as blocks that contain one or more bad bits. Do not erase or program factory-marked bad blocks. Refer to the attached technical notes for a appropriate management of invalid blocks. 2. The lst block, which is placed on OOh block address, is fully guaranteed to be a valid block, does not require Error Correction. PC612H503AX30 on stock The P-channel MOSFET requires no base drive current, which reduces quiescent current considerably. PNP- based regulators waste considerable amounts of cur- rent in dropout when the pass transistor saturates. They also use high base-drive currents under large loads. The MAX8863/MAX8864 do not suffer from these prob- lems, and consume only 80pA of quiescent current, whether in dropout, light load, or heavy load applica- tions (see Typical Operating Characteristics). | PARAMETER | TEST CONDITIONSo) | MIN TYP MAX | UNIT | | POWER SWITCH | | | | la = 750 mA each | 85 110 | ml | | 3.3V to AVCC | lo = 750 mA each, Tj = 1000C | 110 140 | | 5V to AVCC | la = 500 mA each | 95 130 | | Static drain-source | la = 500 mA each, Tj = 1000C | 120 160 | | rOS(on) on-state resistance | | lo = 50 mA each | 0 8 1 | | | 3.3V or 5V to AVPP | la = 50 mA each, Tj = 1000C | 1 1 3 | l | | | la = 50 mA each | 2 2 5 | | 12V to AVPP | lo = 50 mA each, Tj = 1000C | 2 5 3.4 | | Output discharge | Discharge at AVCC | 10(disc) = 1 mA | 0 5 0 7 1 | kl | | resistance | Discharge at AVPP | 10(disc) = 1 mA | 0 2 0 4 0.5 | | | Limit (steady-state value), output | IOS(AVCC) | 1 1 4 2 | A | | powered into a short circuit | IOS(AVPP) | 120 200 300 | mA | | los Short-circuit output current | Limit (steady-state value), output | IOS(AVCC) | 1 1 4 2 | A | | powered into a short circuit, Tj = 1000C | IOS(AVPP) | 120 200 300 | mA | | TJtemperashutdow | Thermal trip point | Rising temperature | 135 | oc | | Hysteresis | | 10 | | | 5V to AVCC = 5 V, with 100-m I short to GND | 10 | | | Current-Iimit response time (2}(3) | 5V to AVPP = 5 V, with 100-ml short to GND | 3 | LJs | | | | ll(3 3v1 | | 140 200 | | | Normal operation | 11(5v) | Vo(AVCC) = Vo(AVPP) = 3.3 V and also for RESET = 0 V | 8 12 | | ~nn~ut current, quiesc- | 11(12V) | 100 180 | | | ll(3 3v1 | | 0 3 2 | pA | | Shutdown mode | 11(5v) | Vo(AVCC) = Vo(AVPP) = Hi-Z | 0 1 2 | | 11(12V) | 0 3 2 | | | | | | | |
|
