QTCW2012-090-LF Datasheet| | | Charact eristics | | | | Items | Symbols | ln | t y;l | IaX | Condi tioris | Units | | | R Lh (j-c) | | | 0.278 | IGBT | | | Thermal | Rth (j-c) | | | 0.533 | Diode | | resistance | R th(c-f) | | 0.025 | | the base to cooling fin | cW | | | | | | | |
QTCW2012-090-LF Price| Electrostatic Discharge Sensitive Device according to MIL-STD 883 | | Test-Normen Villach/Pruffeld |
QTCW2012-090-LF on stock| PIN NAME l/0 DESCRIPTION | | 1 | \HS | O | High Speed indicator, output, active LO, TTL/CMOS. Low when operating at 2400bps rate, high otherwise. | | 2 | \CMD | | Command Enable is not supported on the XE2476. This pin is open internally. | | 3 | \AAD | | The Automatic Answer Disable pin is not supported in the XE2476. Register SO controls automatic answer operation. | | 4 | \DCD | O | The operation of Data Carrier Detect is controlled by the &C command. DCD may be configured to remain active, DCD low, or may go low to indicate receipt of valid carrier. | | 5 | \DTR | I | Data Terminal Ready is an active low input The function of this pin is set by the &D command and the value in register S21. Normally, the modem ignores DTR. | | | | |
Printed wiring board direct mounting type Gap: 3mm Resolution: Slit width 0.5mm Digital output (with a pull-up resistor) TLP1004A(F): Low level output at shielding TLP1005A(F): High level output at shielding Built-in schmitt circuit Threshold input current: 4mA (max.) at Ta = 250C Operating supply voltage: VCC = 4.5V~17V High speed response Detector side is of visible light cut type
|
