| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
|
R1110N251B-TR - FFOX Datasheet The S3C826A microcontroller is also available in OTP (One Time Programmable) version, S3P826A. The S3P826A microcontroller has an on-chip 48K-byte one-time-programmable EPROM instead of masked ROM. The S3P826A is comparable to S3C826A, both in function and in pin configuration. R1110N251B-TR - FFOX Price I Anyone purchasing any products described or contained herein for an above-mentioned use shall: Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and expenses associated with such use: Not impose any responsibilty for any fault or negligence which may be cited in any such claim or litigation on SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees jointly or severally. R1110N251B-TR - FFOX on stock Writing the reset command to the device resets the device to reading array data. Address bits are don't care for this command. The reset command may be written between the sequence cycles in an erase command sequence before erasing begins. This resets the device to reading array data. Once erasure begins, however, the device ignores reset commands until the operation is complete. The reset command may be written between the sequence cycles in a program command sequence before programming begins. This resets the device to reading array data (also applies to programming in Erase Suspend mode). Once programming begins, however, the device ignores reset commands until the operation is complete. The reset command may be written between the sequence cycles in an autoselect command sequence. Once in the autoselect mode, the reset command must be written to return to reading array data (also applies to autoselect during Erase Suspend). If l/Os goes high during a program or erase operation, writing the reset command returns the device to reading array data (also applies during Erase Suspend).
|
