| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| RC0402FR-0751R1L | YAGEO; | 06+ | 4416 |
|
|
RC0402FR-0751R1L Datasheet RF Micro Devices believes the furnished information is correct and accurate at the time of this printing. However, RF Micro Devices reserves the right to make changes to its products without notice. RF Micro Devices does not assume responsibility for the use of the described product(s) RC0402FR-0751R1L on stock Notes: (1) The device enters the active state after any start, and remains active until: 9 clock cycles later if the device select bits in the slave address byte are incorrect; 200ns after a stop ending a read operation; or twc after a stop ending a write operation. (2) The device goes into standby: 200ns after any stop, except those that initiate a nonvolatile write cycle; twc after a stop that initiates a nonvolatile cycle; or 9 clock cycles after any start that is not followed by the correct device select bits in the slave address byte. (3) VIL min. and VIH max. are for reference only and are not tested. The LA7210/7212 are sync detector lC's designed to obtain the optimum reception mode in the channel select system of a VTR. The use of a ceramic resonator-applied horizontal sync detector of VCO, PLL type can provide a non-adusting system with high detect accuracy. The LA7210/7212 also meet the require- ments of the new FTZ in West Germany. s When routing differential pairs, keep the trace length identical between the two traces. Differences in trace lengths translate directly into signal skew. When separations occur, the differential impedance may be affected so take care when this is done. |
