| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| RS9702-01A | KRS | QFP | 131 |
|
|
RS9702-01A Datasheet 4: Regulation is measured at a constant junction temperature using low duty cycle pulse testing. Load regulation is tested over a load range from l.0 mA to the maximum specified output current. Changes in output voltage due to heating effects are covered by the thermal regulation specification. 5: Dropout voltage is defined as the input-to-output differential at which the output voltage drops 2% below its nominal value at a V differential. 6: Thermal Regulation is defined as the change in output voltage at a time T after a change in power dissipation is applied, excluding load or line regulation effects. Specifications are for a current pulse equal to IMAX at VIN = 6V for T = 10 msec 7: The maximum allowable power dissipation is a function of ambient temperature, the maximum allowable junction tem- perature and the thermal resistance from junction-to-air (i.e. TA, Tj, OJA). 8: Time required for VOUT to reach 95% of VR (output voltage setting), after VSHDN iS switched from O to VIN. RS9702-01A Price Peak Collector Current (Tj " 150YC) ICM 300* Amperes Emitter Current" (Tc = 25IC) IE 150 Amperes RS9702-01A on stock If there is no need for the control unit to handle external analog signals referred to the power GND, the best approach is to connect the reference potential of the control unit to the device ground (see application circuit in fig. 3), which becomes the common signal GND for the whole control board avoiding shift of Viri, ViI and Vstat. LOW SIDE SWITCHES The devices integrate: - OVERVOLTAGE CLAMP PROTECTION: internally set at 42V, along with the rugged avalanche characteristics of the Power MOSFET stage give this device unrivalled ruggedness and energy handling capability. This feature is mainly important when driving When the potential on Pin 6 reaches the nominal value predetermined at Pin 9, then a trigger pulse is generated whose width tp iS determined by the value ofC2 (the value ofC2 and hence the pulse width can be evaluated by assuming 8 ys/nF). At the same time, a latch is set, so that as long as the automatic retriggering has not been activated, then no more pulses can be generated in that half cycle. |
