| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
|
RSS2FGTA Datasheet The reference divider is clocked by the signal at pin XTAL. The applied input signal should be AC-coupled. The circuit operates with levels from 50 up t0 500 mV (RMS) and at frequencies from 3 t0 35 MHz. Any divide ratios from 8 t0 2047 inclusive can be programmed. RSS2FGTA Price Panasonic is endeavoring to continually improve the quality and reliability of these materials but there is always the possibility that further rectifications will be required in the future. Therefore, Panasonic will not assume any liability for any damages arising from any errors etc. that may ap- pear in this material. RSS2FGTA on stock - Subject to local technical requirements and regulations, availability of products included in this promotional material may vary. Please consult with our sales office Information furnished by HAMAMATSU is believed to be reliable. However, no responsibility is assumed for possible inaccuracies or omissions. Specifications are subject to change without notice. No patent rights are granted to any of the circuits described herein. @ 1999 Hamamatsu Photonics K.K. Note l: Measured with heater voltage of 6.3V and no anode input power, the heater current limits are l.1A minimum, 1.4A maximum. For average pulse input powers greater than 28 watts, the heater voltage must be reduced within 3 seconds after the application of h. t. according to the following schedule: |
