| TEST PROCEDURES AND REQUIREMENTS |
| TEST | PROCEDURE | REQUIREMENTS |
| NAME OF TEST | REFERENCE | (quick reference) |
| Endurance | IEC 60 384-4/ EN130300, subclause 4.'13 | Tamb = 85 0C; UR applied; 1000 hours | AC/C: +20% tan 8 i 2 x spec. limit IL2 i spec. Iimit |
| U seful life | CECC 30301, subclause l.8.1 | Tamb = 85 0C; UR and IR applied; 1500 hours | AC/C: +50% tan 8 i 3 x spec. limit Z < 3 x spec. limit IL2 < spec. limit no short or open circuit total failure percentage: .< 3% |
| S helf life (storage at high temperature) | IEC 60384-4/ EN130300, subclause 4.17 | Tamb = 85 0C; no voltage applied; 500 hours after test: UR to be applied for 30 minutes, 24 t0 48 hours before measurement | AC/C, tan 8, Z: for requirements see 'Endurance test' above IL2 i spec. limit |
| | | |
Each window has a button near the top. It's labeled either HOLD or PASS. The setting is toggled by clicking on this button. When set to HOLD, the user can change the settings in a window but they will not be written to the register(s) until the OK button (which appears at the bottom left corner ofthe window) is pressed. When set to PASS, changes made within a window are immediately written to the correspond- ing register(s). The Attenuation Window
| Parameter | Symbol | Condition | Min Typ Max | Units |
| INITIAL ACCURACY1 "E" Grade "F" Grade "G" Grade | Vo | IOUT=0 mA | 2.046 2.048 2.050 2.043 2.053 2.038 2.058 | V V V |
| LINE REGULATION2 "E" Grade "F & G" Grades | O/CVIN | 3.0 V" Vs " 15 V,IOUT = O mA | 2 4 4 8 | ppmN ppmN |
| LOAD REGULATION2 "E" Grade "F & G" Grades | qjV O/CVLOAD | Vs = 5.0 V, 0 " IOUT " 30 mA | 4 lO 6 15 | ppm/mA ppm/mA |
| DROPOUT VOLTAGE | Vs - VO | Vs = 3.15 V,ILOAD = 2 mA Vs = 3.3 V) ILOAD = 10 rriA Vs = 3.6 V,ILOAD = 30 mA | 0.95 1.25 1.55 | V V V |
| LONG-TERM STABILITY3 | | 1000 Hours +125IC | 1.2 | mV |
| NOISE VOLTAGE | eN | 0.1 Hz t0 10 Hz | 20 | ccV p-p |
| | | | |
