MOTMap-11  > RT8009-15PJ5

suppliers of RT8009-15PJ5 and PDF data of RT8009-15PJ5

Part Numbert Mfg Packt D/C Descriptiont Qty Company/Contact  
RT8009-15PJ5 RICHTEK  SOT-23-5      8809 
    Haodexin Electronic Co Limited
  • Contact:Cathy Lu
  • Tel:00852-30592291
  • Fax:00852-30592292
  • Email: sales8@haodexin.com


RT8009-15PJ5 RICHTEK  TSOT23-5  08+    2809 
    A-RICH HK LECTRON CO.,LIMITED
  • Contact:JING ZHOU
  • Tel:86-755-33377586
  • Fax:86-755-33377578
  • Email: ARICH2@yahoo.cn


RT8009-15PJ5 RICHTEK    08+    30000 
    All Element Technology Co.,Ltd
  • Contact:lisa
  • Tel:86-755-82565926
  • Fax:86-755-82565338
  • Email: lisa@allelement.net
RT8009-15PJ5 RICHTEK  TSOT23-5  08+  OWN STOCK  2809 
    PTS COMPONENT EUROPE ( SE ASIA..
  • Contact:Sun
  • Tel:852-30723852
  • Fax:852-30723853
  • Email: vincent@ptsce.com
RT8009-15PJ5 RICHTEK    08+  new and original  3,000 
RT8009-15PJ5 RICHTEK    08+  new and original  3000 
RT8009-15PJ5 RICHTEK  pb free  08+  绝对原装,特价销售!  3000 
    North Technology Co.,Ltd
  • Contact:JOJO
  • Tel:86-10-82637263
  • Fax:86-10-82639385
  • Email: jojo@northelec.com

RT8009-15PJ5 Datasheet
Product Description The CMCPC1102BT/BR is a 10-channel backplane interface/termination lC specifically designed for Com- pactPCI redundant system-slot cards. The CMCPC1102BT/BR allows CompactPCI boards to interface to the backplane and provides the versatility to use system cards in any slot (system or peripheral). Per the CompactPCI specification, the CMCPC1102BT/ BR provides a 10Q termination resistor for each chan- nel to terminate the transmission line stub on the board. An integral series switch and associated control signal (SW_EN) permits connection/disconnection of the channel, so that the device side of the circuit may be isolated from the backplane side.
RT8009-15PJ5 Price
Page Program(True) and Copy-Back Program(True) are available on l plane operation. Page Program(Dummy) and Copy-Back Program(Dummy) are available on the 2nd, 3rd, 4th plane of multi-plane operation The 71h command should be used for read status of Multi Plane operation. Any undefined command inputs are prohibited except for above command set of Table l.
If the lamp does not ignite, the voltage level increases. When the lamp voltage exceeds the Vlamp(max) level, the voltage will be regulated at the Vlamp(max) level; see Fig.6. At crossing the Vlamp(fail) level the ignition timer was already started. If the voltage at pin LVS is above the Vlamp(fail) level at the end of the ignition time the circuit stops oscillating and is forced in a Power-down mode. The circuit will be reset only when the supply voltage is powered-down.