| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| RT8612 | . | . | . | 5 |
|
 
|
|
| RT8612 | . | . | . | 5 |
|
|
|
| RT8612 | IC'S | 1000 |
|
|
RT8612 Datasheet TI warrants performance of its hardware products to the specifications applicable at the time of sale in accordance with TI's standard warranty. Testing and other quality control techniques are used to the extent TI deems necessary to support this warranty. Except where mandated by government requirements, testing of all parameters of each product is not necessarily performed. RT8612 Price GENERAL DESCRIPTION Offered in 128Mx8bit the K9FIG08XOA is lG bit with spare 32M bit capacity. Its NAND cell provides the most cost-effective solution for the solid state mass storage market. A program operation can be performed in typical 300Us on the 2112-byte page and an erase operation can be performed in typical 2ms on a 128K-byte block. Data in the data page can be read out at 50ns (30ns, K9FIG08UOA) cycle time per byte. The l/0 pins serve as the ports for address and data input/output as well as command input. The on-chip write controller automates all program and erase functions including pulse repetition, where required, and internal verification and margin- ing of data. Even the write-intensive systems can take advantage of the K9FIG08XOA's extended reliability of 100K program/erase cycles by providing ECC(Error Correcting Code) with real time mapping-out algorithm. The K9FIG08XOA is an optimum solution for large nonvolatile storage applications such as solid state file storage and other portable applications requiring non-volatility. RT8612 on stock The high-frequency oscillator (RFLO oscillator) supplies the local oscillator signal for the down-conversion (receive) and up-conversion (transmit) mixers. This VCO uses an on-chip regulator for a power-supply voltage-independent output frequency. The buffered VCO signal is fed into a phase shifter and an off-chip prescaler-synthesizer. The output signal of the phase-shifter is used for driving the RX and TX mixers. Due to the good isolation in the buffer stages, a very small change in VCO frequency is obtained when switching the RX and TX mixers on.
|
