SKR32016UNF，there are the best SKR32016UNF suppiers all over the world here.These are the list and detailed contact method of SKR32016UNF suppliers all over the world as follows.You can buy or get informations of SKR32016UNF through email , message or tel.

suppliers of SKR32016UNF and PDF data of SKR32016UNF

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

SKR32016UNF Datasheet

Rbreak 17 18 RbreakMOD 1 Rdrain 50 16 RdrainMOD 3.7e-3 Rgate 9 20 3.53 RSLC1 5 51 RSLCMOD le-6 RSLC2 5 50 1e3 Rsource 8 7 RsourceMOD 22e-3 Rvthres 22 8 RvthresMOD 1 Rvtemp 18 19 RvtempMOD 1 Sla 6 12 13 8 SIAMOD Slb 13 12 13 8 SIBMOD S2a 6151413 S2AMOD S2b 13 15 14 13 S2BMOD
SKR32016UNF Price


Vcc +5V supply	1
Serial Data Input, 2400bps	2
Busy Output. Goes high whilst transmitting. Active High	3
Mode Pin high (Vcc) selects transmit mode	4
Test Input sends pre-set message. Active Low	5
Transmit Data Output to RF transmitter	6
Transmit Enable Output to RF transmitter. Active High	7
Ground. 0 Volt	8
	Vcc

SKR32016UNF on stock

1.4

0 1.2

o, :g 1.0 o 3 0.8

± > 4.09

LL 0.6

0.1 1 10 100 1000 Forward Current (mA) Forward Characteristics

-40 -20 0 20 40 60 80 100 Temperature (oC) Temperature Drift

1000

IIIIIIIIIII1 iref:150pA-7TI I

1 5 1

100

- iref-5mA

0 0 5

---- - ---- - Ta-85'C

a 1 n1

0.1 1 10 Reference Current {mA) Slope Resistance vs. Current

10 100 1K 10K 100K Frequency (Hz} Slope Resistance vs. Frequency

150pAVIN

2 o

VIN 1:2A{

5K2A750:cA

0 200 400 600 Time {ps) Transient Response [Single Pulse)

0246 Time (ps) Transient Response (Repetitive Pulsel

SYMBOL	PIN	TYPE	DESCRIPTION
nC	36		not connected
nC	37		not connected
nC	38		not connected
nC	39		not connected
nC	40		not connected
FRAME	41	O	de-interlace output synchronized with the VSYNC pulse to produce a non-interlaced display by adjustment of the vertical deflection circuits
VPE	42	l	OTP programming voltage input; connect to ground
COR	43	O	output which allows selective contrast reduction of the TV picture to enhance a mixed mode display; open-drain; active LOW
nC	44		not connected
VDDA	45		3.3 V analog supply voltage
B	46	O	pixel rate output of the blue colour information
G	47	O	pixel rate output of the green colour information
R	48	O	pixel rate output of the red colour information
nC	49		not connected
nC	50		not connected
nC	51		not connected
VDS	52	O	video or data switch push-pull output for dot rate fast blanking
HSYNC	53	l	Schmitt-triggered input for a TTL-Ievel version of the horizontal sync pulse; the polarity of this pulse is programmable by register bit TXTl.H POLARITY
nC	54		not connected
VSYNC	55	l	Schmitt-triggered input for a TTL-Ievel version of the vertical sync pulse; the polarity of this pulse is programmable by register bit TXTl.V POLARITY
nC	56		not connected
nC	57		not connected
nC	58		not connected
nC	59		not connected
VSsP	60		periphery ground
nC	61		not connected
VSsc	62		core ground
VDDC	63		3.3 V core supply voltage
nC	64		not connected
nC	65		not connected
nC	66		not connected
nC	67		not connected
nC	68		not connected
OSCGND	69		crystal oscillator ground
XTALIN	70	l	12 MHz crystal oscillator input
XTALOUT	71	O	12 MHz crystal oscillator output
RESET	72	J	reset input; if LOW for at least 24 crystal oscillator periods while the oscillator is running, the device is reset; internal pull-up

Suppliers Datasheet
		Exact Matc