| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
|
SKR470M1VD11 PITCH2 Datasheet NOTE: 1. CPD iS used to determine the dynamic power dissipation (PD in W) PD = CPD X VCC2 x fi +E (CL X VCC2 x fo) where: fi = input frequency in MHz; CL = output load capacity in pF; fo = output frequency in MHz; Vcc = supply voltage in V; E (CL x VCC2 x fo) = sum of the outputs. SKR470M1VD11 PITCH2 Price INo products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment, nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of which may directly or indirectly cause injury, death or property loss. SKR470M1VD11 PITCH2 on stock
If the offset mixer in the W3011 is not required for the frequency plan, the offset mixer may be turned off by connecting the positive supply (Vcc) to any or all of pins 11 (LOHN), 12 (LOHP), 13 (LOLN), or 14 (LOLP), as illustrated in Figure 5 below. Disabling the offset mixer reduces current consumption 2 mA t0 3 mA. If pin 11 is connected to Vcc, pins 12, 13, and 14 must be connected to Vcc or no-connect (NC). Connect the RF VCO to either pin 9 0r pin 10 through a low-impedance coupling capacitor, and connect the unused pin (10 0r 9) through a similar capacitor to ground. |
