| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
|
SKT 12-04E Datasheet Note b: ICC, and ICC3 are dependent on output loading and cycle rate. The specified values are obtained with outputs unloaded. Note c: Bringing E > VIH will not produce standby current levels until any nonvolatile cycle in progress has timed out See MODE SELECTION table Note d: VCC reference levels throughout this datasheet refer to Vccx if that is where the power supply connection is made, or VCAP if Vccx is connected to ground SKT 12-04E Price
SKT 12-04E on stock
Notes: 1. Maximum alignment deviation between leads not to be greater than 0.2 mm. 2. Maximum non-cumulative variation between tape feed holes shall not exceed l mm in 20 pitches 3. Hold-down tape not to exceed beyorld the edge(s) of carrier tape and there shall"be no exposure of adhesive. 4. No more than 3 consecutive missing components permitted. 5. A tape trailer, having at least three feed holes is required after.the last component. 6. Splices shall not interfere with the sprocket feed holes. . |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
