SKT5S Datasheet| Part Number | Color | Material | Lens | Viewing Angle | Luminous Intensity (mcd) | Forward Voltage (V) | Peak Wave Length | | Color | typ. | min | typ. | @mA | typ. | max | @mA | nm | | MTSM2142A-UR | RED | GaAIAs ON GaAs | Water Clear | 300 | 280 5 | 484 5 | 20 | 1 7 | 2.4 | 20 | 660 | | | | | | | | | | | | |
SKT5S Price Note l: Limits at -400C are not production tested and are guaranteed by design. Note 2: Voltage referenced to ground. Note 3: Outputs are open. Note 4: The IRQ, PWR, and RST outputs are open drain. Note 5: Value for voltage and currents is from the Vcc, input pin to the Vcco pin. Note 6: If VPF iS less than VBAT and VBAUX, the device power is switched from Vcc to the greater of VBAr or VBAUX when Vcc drops below VPF. If VPF is greater than VBAr and VBAUX, the device power is switched from Vcc to the greater of VBAr or VBAUX when Vcc drops below the greater of VBAr or VBAUX. Note 7: Value for voltage and currents is from the VBAr or VBAUX input pin to the Vcco pin. Note 8: IBAr, and IBAr2 are specified with Vcco floating and do not include any RAM current. Note 9: VBAT or VBAUX current. Using a 32,768Hz crystal connected to Xl and X2. Note 10: These parameters are sampled with a 5pF load and are not 100% tested. Note 11: Typical values are at +25aC, nominal (active) supply, unless otherwise noted. Note 12: If the oscillator is not enabled, the startup time of the oscillator after Vcc, is applied is added to the wakeup/kickstart timeout. SKT5S on stock| Symbol | Before | After | | ICC2P ,ICC3P | CKE i VIL(max), tcc = 15ns | CKE iViL(max), tcc = 10ns | | ICC2N ,ICC3N | CKE > VIH(min), CS > VIH(min), tcc = '15ns Input signals are changed one time during 30ns | CKE > VIH(min), CS > VIH(rliin), tcc = 10ris Input signals are changed one time during 20ns | | ICC4 | 2 Banks activated | 4 Banks activated | | | |
|
