| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| SL440AJE | 00+ | 2500 |
|
SL440AJE Datasheet
SL440AJE Price 2) when an output is energized, that drain cur- rent fails to exceed the Open Load Detection Current, loson, after the Open Load On Sense Time, toson. In case l the status line will remain low until the voltage level at that drain exceeds Vooff or until a non-faulted output is energized. In case 2 the Status line will remain low until the current is greater than loson or until that output is turned oft. After the open condition is removed, the output will operate normally and the Status line will no longer indicat a fault. Refer to Figure 4 & 5 for the open load condition wavetorms. SL440AJE on stock If the input is pulled to power GND, a negative voltage of -Vf iS seen by the device. (ViI, Vih thresholds and Vstat are increased by Vf with respect to power GND). The undervoltage shutdown level is increa- sed by Vf. If there is no need for the control unit to handle external analog signals referred to the power GND, the best approach is to connect the reference potential of the control unit to node [1] (see application circuit in fig. 3), which becomes the common signal GND for the whole control board avoiding shift of Vih, ViI and Vstat. This solution allows the use of a standard diode.
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
