SUD50N03-09P-Q，there are the best SUD50N03-09P-Q suppiers all over the world here.These are the list and detailed contact method of SUD50N03-09P-Q suppliers all over the world as follows.You can buy or get informations of SUD50N03-09P-Q through email , message or tel.

suppliers of SUD50N03-09P-Q and PDF data of SUD50N03-09P-Q

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

SUD50N03-09P-Q Datasheet

FEATURES Demodulator and decoder section DSP section Analog audio section GENERAL DESCRIPTION Supported standards ORDERING INFORMATION BLOCK DIAGRAM PINNING FUNCTIONAL DESCRIPTION Description of the demodulator and decoder section Description of the DSP Description of the analog audio section LIMITING VALUES THERMAL CHARACTERISTICS CHARACTERISTICS 12C_BUS CONTROL Introduction Power-up state Slave receiver mode Slave transmitter mode Expert mode 12S_BUS DESCRIPTION EXTERNAL COMPONENTS APPLICATION CIRCUITRY PACKAGE OUTLINE SOLDERING Introduction Soldering by dipping or by wave Repairing soldered joints DEFINITIONS LIFE SUPPORT APPLICATIONS PURCHASE OF PHILIPS I2C COMPONENTS
SUD50N03-09P-Q Price

The AZ10EL89 is a differential fanout gate specifically designed to drive coaxial cables. The device is especially useful in Digital Video Broadcasting applications. For this application, since the system is polarity free, each output can be used as an independent driver. The driver has a voltage gain of approximately 40 and produces an output swing twice as large as standard ECL output. When driving a coaxial cable, proper termination is required at both ends of the line to mimnuze signal loss. The l.6 V output swing allows for termination at both ends of the cable, while maintaining the required 800 mV swing at the receiving end of the cable. Because of the larger output swings, the device cannot be terminated into the standard Vcc -2.OV. All of the DC parameters are tested with a 50Q to Vcc -3.OV load. The driver accepts a standard differential ECL input and can run off of the Digital Video Broadcast standard -5.OV supply. Under open input conditions (pulled to VEE) internal input clamps will force the Qn output LOW. NOTE: Specifications in ECL/PECL tables are valid when thermal equilibrium is established.
SUD50N03-09P-Q on stock

Vo Required RSET	Vo Required RSET	Vo Required RSET
-15.0 V 99 l	-11.9 V 2.09 kl	-8.8 V 6.21 kl
-14.9 V 147 l	-11.8 V 2.18 kl	-8.6V 6.63 kl
-14.8 V 196 l	-11.7 V 2.27 kl	-8.4V 7.09 kl
-14.7 V 24s l	-11.6 V 2.36 kl	-8.2V 7.58 kl
-14.6 V 296 l	-11.5 V 2.45 kl	-8.0 V 8.11 kl
-14.5 V 347 l	-11.4 V 2.55 kl	-7.8V 8.68 kl
-14.4 V 400 l	-11.3 V 2.65 kl	-7.6V 9.30 kl
-14.3 V 453 l	-11.2 V 2.75 kl	-7.4V 9.98 kl
-14.2 V 507 l	-11.1 V 2.82 kl	-7.2V 10.7 kl
-14.1 V 562 l	-11.0 V 2.96 kl	-7.0 V 11.5 kl
-14.0 V 619 l	-10.9V 3.07 kl	-6.8V 12.4 kl
-13.9 V 676 l	-10.8V 3.18 kl	-6.6V 13.4 kl
-13.8 V 734 l	-10.7V 3.29 kl	-6.4V 14.6 kl
-13.7 V 794 l	-10.6 V 3.41 kl	-6.2V 15.8 kl
-13.6 V 854 l	-10.5V 3.53 kl	-6.0V 17.3 kl
-13.5 V 916 l	-10.4V 3.65 kl	-5.8V 18.9 kl
-13.4 V 979 l	-10.3V 3.78 kl	-5.6V 20.7 kl
-13.3 V 1.04 kl	-10.2 V 3.91 kl	-5.4V 22.9 kl
-13.2 V 1.11 kl	-10.1 V 4.04 kl	-5.2V 25.6 kl
-13.1 V 1.18 kl	-10.0V 4.18 kl	-5.0V 28.7 kl
-13.0 V 1.24 kl	-9.9V 4.33 kl	-4.8V 32.5 kl
-12.9 V 1.31 kl	-9.8V 4.47 kl	-4.6V 37.2 kl
-12.8 V 1.38 kl	-9.7V 4.62 kl	-4.4V 43.4 kl
-12.7 V 1.46 kl	-9.6V 4.78 kl	-4.2 V 51.6 kl
-12.6 V 1.52 kl	-9.5V 4.94 kl	-4.0V 63.0 kl
-12.5 V 1.60 kl	-9.4V 5.10 kl	-3.8 V 80.1 kl
-12.4 V 1.68 kl	-9.3V 5.27 kl	-3.6V 109 k
-12.3 V 1.76 kl	-9.2V 5.45 kl	-3.4V 166 k
-12.2 V 1.84 kl	-9.1 V 5.63 kl	-3.2V 338 k
-12.1 V 1.92 kl	-9.0V 5.82 kl	-3.0V OPEN
-12.0 V 2.01 kl	-8.9 V 6.01 kl

Each of the RV5VH series is dual output CMOS DC/DC converter ICs integrating Step-up and inverting DC/DC convert- ers. The RV5VH3x x series ICs consists of an oscillator, two VFM control circuits, control transistors (EXT switches), a phase shift circuit, a voltage reference unit, an error amplifier, and voltage sensing resistors. The package for the RV5VH series is 8pin SSOP(0.65mm pitch), and it is suitable for power supply systems with positive and negative output, such as pager, PDA, which need power supplies for LCD. RV5VHlx x and RV5VH2x x series are able to provide two DC/DC converters, one is a step-up DC/DC converter with intemally fixed output and the other is an inverting DC/DC converter with adjustable output by external resistors. A volt- age detector with sensing pin is also included. RV5VH3x x series are able to provide two DC/DC converters, both ofthem require external drivers, DC/DCl, and inverting one, DC/DC2, can be adjustable by resistors.

Suppliers Datasheet
		Exact Matc