| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
|
SV9000 Datasheet The STK12C68 is a high-speed memory and so must have a high-frequency bypass capacitor of approximately O.lccF connected between VCAP and Vss, using leads and traces that are as short as pos- sible. As with all high-speed CMOS ICs, normal care- ful routing of power, ground and signals will help prevent noise problems. SV9000 Price
SV9000 on stock "In the absence of confirmation by device specrfication sheets, WARP taker) no responsibility for any defects that occur In equipment usmg any of SHARP's devices.shown m catalogs data books,etcContact WARP in waler toobtainlhelateslveonoflhedevicespecificalionsheetsbefore using any SHARP'sdevice." Weight VerticaUHorizontal - 26 gmIIls Flammability Meets UL 94V-O Notes: (1) The Standby (lzn 3) bas an internal pull-up to Vin, and if it is left open circuit the module will operate when input power is applied.Refer to the application notes for inte7face considenitions. (2) The total combined ESR of all output capacitance at 100k Hz must be (less tban) <50 m / . (3) For operatiizg tem.peratures below OoC, Cin and Cout must Inive stable characteristics. Use eitber tantalum or Oscon~ capacitors. (4) See Safe Operating Area curves for the specific OZLtpUt voltage combiation, or contact tbe factory for the appropriate derating. Input/0 utput C apacitors : I he PT6980 series requires a 330y Felectrolytic capacitor at botb the input a72d output for proper operation (300 F for Osc07z~ or lo ESR tantalum). In ra:ddition, the input capacitance must be na:ted for a minimum of I.OArms ripple current. For transient or dynamic load applicatios, additional capacitance may be required. Refer to the application notes for more inforwnitioiz. |
