TBJA156M006CR，there are the best TBJA156M006CR suppiers all over the world here.These are the list and detailed contact method of TBJA156M006CR suppliers all over the world as follows.You can buy or get informations of TBJA156M006CR through email , message or tel.

suppliers of TBJA156M006CR and PDF data of TBJA156M006CR

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
TBJA156M006CR	AVX	in stock			07+	TordElectronics(hk)Co.,Limited Contact:Mr.zhudavid Tel:86-755-83227940 Fax:86-755-83229740 Email: tordseller@126.com

TBJA156M006CR Datasheet

JEDEC PARAMETER NAME	PARAMETER NAME	DESCRIPTION	BS616UV4010-70 BS616UV4010-10 MIN. TYP. MAX. MIN. TYP. MAX.			UNIT
t	t RC	Read Cycle Time	70	100		ns
tAvov	t	Address Access Time		70	100	ns
tELov	tAcs	Chip Select Access Time . (CE)		70	100	ns
t	t (1)	Data Byte Control Access Time . (LB,UB)		35	50	ns
tGLQv	toE	Output Enable to Output Valid		35	50	ns
t ELQX	t CLZ	Chip Select to Output Low Z . (CE)	10	15		ns
t	t	Data Byte Control to Output Low Z . (LB,UB)	10	15		ns
tGLQx	t^,z	Output Enable to Output in Low Z	10	15		ns
tEHQz	tz	Chip Deselect to Output in High Z (CE)	0	35 0	40	ns
tBDo tGHoz	tBDo toHz	Data Byte Control to Output High Z (LB,UB) Output Disable to Output in High Z	0 0	35 0 30 0	40 35	ns ns
l	t OH	Output Disable to Address Change	10	15		ns

TBJA156M006CR Price

From the No Bat state,there is only one possible transition. The No Bat state can move to the Charge state ifthe voltage on the BAT pin remainslessthan VMAX forone second. The LTC1729 will now work on the assumption that a new battery has been installed.

Note: 1. Stresses greater than those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational section of this specification is not implied. Exposure to the absolute maximum rating conditions for extended periods of time may affect relia bility. 2. Soldering temperature not to exceed 2600C for 10 seconds (total thermal budget not to exceed 1500C for longer than 30 seconds). CAUTION: Negative undershoots below -0.3V are not allowed on any pin while in the Battery Back-up mode. CAUTION: Do NOT wave solder SOIC to avoid damaging SNAPHAT sockets.

Product design and specifications subject to change without notice Pr02000 is a tradEmark of Harris (orporation All other trademarks belong to tHeir respective companies

Suppliers Datasheet
		Exact Matc