TPS60111PWPG4 Datasheet| Parameter | Symbol | Conditions | Min | Typ | Max | Unit | | Collector-emitter voltage | 2SB0951 | VCEO | IC = -30 rriA, IB = 0 | -60 | | | V | | (Base open) | 2SB0951A | -80 | | | | Collector-base cutoff | 2SB0951 | ICBO | VCB = -60 V, IE = 0 | | | -100 | yA | | current ( Emitter open) | 2SB0951A | VCB = -80 V, IE = 0 | | | -100 | | Emitter-base cutoff current (Collector open) | IEBO | VEB = -7 V,IC = O | | | 2 | mA | | Forward current transfer ratio | hFEI8 | VCE = -3 V, IC = -4 A | 1 000 | | 10000 | | | hFE2 | VCE = -3 V,IC = -8 A | 500 | | | | Collector-emitter saturation voltage | VCE(sat) | IC = -4 A,IB = -8 mA | | | -1.5 | V | | Base-emitter saturation voltage | VBE(szU) | IC = -4 A,IB = -8 mA | | | -2.0 | V | | Transition frequency | fT | VCE = -10 V,IC = -1 A, f = 1 MHz | | 20 | | MHz | | rurn-on time | tn | Ic = -4 A,IBl = -8 mA,IB2 = 8 mA | | 0 5 | | US | | Storage time | ts | VCc = -50 V | | 2 0 | | !1s | | Fall time | tr | | 1.0 | | 11s | | | | | | | | |
TPS60111PWPG4 Price| | | | T2 250C__ | | | j | 50 | | | | fjJ | 30 | | | | | ---- ' -------- | 15 | | | | | | - 10 | | | | | | | Y | | | IF2 SmA | | r | | | | | | | | | |
TPS60111PWPG4 on stock FEATURES s Improved Digital Phase Detector Eliminates 'Dead Band' Effects s Low Operating Power, Typically 175mW s 1-3GHz Operating Frequency s Complete Phase Locked Loop s High Input Sensitivity s Programmed throughThree-Wire Bus s Wide Range of Reference Division Ratios s Local Storage for Two Frequency Words, giving Rapid Frequency Toggling s Programmable Phase Detector Gain s Power Down Mode Note 1. The DUIPO series required a minimum 10% loading on the output to maintain specified regulation. Operation under no-load condition will not damage these devices, however they may not meet all listed specification 2. BELLCORE TR-NWT-000332. Case l: 50% Stress, Temperature at 400C. (Ground fixed and controlled environment). 3. Maximum value at nominal input voltage and full load of standard type 4. Typical value at nominal input voltage and full load. 5. Test by minimum Vin and constant resistor load.
|
