MOTMap-1  > TR-1206FA2.5A

suppliers of TR-1206FA2.5A and PDF data of TR-1206FA2.5A

Part Numbert Mfg Packt D/C Descriptiont Qty Company/Contact  

TR-1206FA2.5A Datasheet
NOTES: 1. Input power with l.5 max output load VSWR. Power handling is reduced when used as a combiner. Consult factory. 2. To equalize the phase at all five ports, add an additional extemal line length to J3 and J5 equivalent t0 1.2 cm of air line, and add a line length to J4 equivalent t0 2.2 cm of air line.
TR-1206FA2.5A Price

Rated load f=50Hz
j
L
-L
h-_


TR-1206FA2.5A on stock

Tj PART GRADE VOUT (NOM) PACKAGEt ORDERABLE PART NUMBER TOP-SIDE MARKINGt
Reel of 3000 LP2981DBVR
ADJ Reel of 250 LP2981DBVT pRV OEW
Reel of 3000 LP2981-125DBVR
1.25V Reel of 250 LP2981-125DBVT pRV OEW
Reel of 3000 LP2981-18DBVR
1.8 V Reel of 250 LP2981-18DBVT PV 3
Reel of 3000 LP2981-25DBVR
2.5 V Reel of 250 LP2981-25DBVT P1
Reel of 3000 LP2981-27DBVR
2.7 V Reel of 250 LP2981-27DBVT P-V OEW
Reel of 3000 LP2981-28DBVR
Standard grade: 2.8 V Reel of 250 LP2981-28DBVT LP5
-400C t0 1250C 1.25% tolerance SOT-23 (DBV) Reel of 3000 LP2981-29DBVR
2.9 V Reel of 250 LP2981-29DBVT PV OEW
Reel of 3000 LP2981-30DBVR
3V Reel of 250 LP2981-30DBVT LP7
Reel of 3000 LP2981-32DBVR
3.2 V Reel of 250 LP2981-32DBVT P-V OEW
Reel of 3000 LP2981-33DBVR
3.3 V Reel of 250 LP2981-33DBVT LPB
Reel of 3000 LP2981-36DBVR
3.6 V Reel of 250 LP2981-36DBVT PEVi
Reel of 3000 LP2981-50DBVR PV 3
5V Reel of 250 LP2981-50DBVT


Figure 8 combines the functions shown in Figures 3 and 8 to provide negative voltage conversion and positive volt- age multiplication simultaneously. This approach would be, for example, suitable for generating +9V and -5V from an existing +5V supply. In this instance, capacitors Ci and C3 perform the pump and reservoir functions, respectively, for the generation of the negative voltage, while capacitors C2 and C4 are pump and reservoir, respectively, for the multi- plied positive voltage. There is a penalty in this configuration which combines both functions, however, in that the source impedances of the generated supplies will be somewhat higher due to the finite impedance of the common charge pump driver at pin 2 0f the device.